User Manual

10
Operating your Sealer
Assembly Instructions
1. Connect the footswitch to the sealer unit.
2. To install the optional working plate and table, remove screws located at the front of the unit and
install the working plate. Adjust working table height according to your bag specifications.
Operation
1. Before operating, check the heating element, PTFE cover, PTFE adhesive and the
silicone rubber.
2. Insert the power cord into the correct receptacle (110V).
3. Turn the power switch on.
4. Choose the appropriate mode: manual or auto. Press the green switch towards MAN for
manual mode and press the switch towards AUTO for automatic mode
a. For manual operation, place the material to be sealed on the lower sealing jaw and press
the foot switch to activate the upper sealing jaw.
b. For auto operation, press the switch towards AUTO to activate automatic sealing. To
turn off the automatic mode and return to manual mode, press the switch towards
MAN. Auto mode enables the upper sealing jaw to open and close automatically based
on the sealing, cooling and recycle settings.
5. Set the SEALING knob to the lowest setting. Always start with a low setting and increase
gradually as needed. Thicker bags will need a higher setting.
6. Set the CONGEALING knob setting. The cooling (congeal) setting button determines the
congealing time for the sealing. For a high quality seal, seals must be able to cool under pressure.
We usually recommend a congeal setting of at least 2x that of the seal setting, but every bag will
have variations. Thicker materials will require a longer cool (congealing) time.
7. Set the RECYCLE knob setting. Recycle time determines the amount of time the
sealing/congealing cycle will reset.. Recycle time is based on the working speed of the operator.
Tips for Successful Sealing
1. If the seal is broken or damaged, decrease the sealing time.