User Manual

Sealer Sales Page 48
ST-1808-28 Tunnel Service Manual
ELECTRICAL PANEL DIAGRAM
5. Wear rail should be 1/8” from edge of chain then tighten
bolt to secure wear rails.
T. Wear rails upper adjustments.
1. Disconnect power to machine.
2. Remove drive and idler end caps.
Note: Take out only ten rollers, then move the open space to
one end. Loosen the one bolt that hold rail in place.
With a screwdriver, pry rail over towards the center. Do
the same on all four corners. Spin conveyor by hand and
check clearance between chain and roller. The distance
should be about 1/16”. Then tighten the two bolts on
each rail.