User Manual

Sealer Sales Page 17
ST-1808-28 Tunnel Service Manual
INSTALLATION
INSTALLATION AND BASIC SET-UP
IMPORTANT
Read this manual carefully, and make it available to everyone
connected with the supervision, maintenance, or production of this
machine. Additional copies are available at your request. (Contact
your distributor for this information.) Be very careful when
operating, adjusting, or servicing this equipment. If in doubt, stop
and obtain qualified help before proceeding.
INSTALLATION OF SHRINK TUNNEL
Place the tunnel in the desired location with the required
electrical power source available. (See power requirements.) Make
certain that proper electrical wiring is provided to guard against low
voltage. If the voltage is too low, the equipment will not function
properly.
Finding the proper location is a most important function of the
initial set-up. One must take several factors into consideration:
1. Adequate power source.
2. Relationship to source of product.
3. Relationship to sealer.
4. Relationship to any conveyors necessary to remove
finished product.
5. Convenience of operator.
6. Avoid drafty areas as heat may be unintentionally
drawn from the tunnel and reduce its efficiency.
An electrician should install a plug on the end of the main
power cord. If there is any doubt, get qualified assistance to do the
initial installation. Do not take any chances!