User Manual

KS- F S I N S T R U C T I O N M A N U A L
9
5. Tighten the screws to affix the PTFE cover plate.
6. If a whole roll of PTFE cover needs to be replaced, loosen the wing nut (Figure 8, Item #46)
found on the plate for PTFE (Figure 8, Item #47) and remove the PTFE roller (Figure 8, Item
#48). Tape one end of the PTFE cover to the rod and roll up the entire piece. Position the PTFE
cover and rod using the plate for PTFE. Ease out enough footage of PTFE cover to cover the
heating element and extend to the front of the PTFE cover plate.
Figure 7. Screw element in place