User Manual

FS- S E R I E S F O O T S E A L E R I N S T R U C T I O N M A N U A L
13
Figure 9. Screw element in place
Figure 10. Lift latch on heating block to screw element in place.
4. Cut off any worn out PTFE cover. Ease out enough footage of PTFE cover to cover the heating
element and extend to the front of the PTFE cover plate.
5. Tighten the screws to affix the PTFE cover plate.
6. If a whole roll of PTFE cover needs to be replaced, loosen the wing nut
(Figure 12, Item #26)
found on the plate for PTFE (Figure 12, Item #F11) and remove the PTFE roller (Figure 12,
Item #F10-1/F10-2/F10-3)
. Tape one end of the PTFE cover to the rod and roll up the entire
piece. Position the PTFE cover and rod using the plate for PTFE. Ease out enough footage of
PTFE cover to cover the heating element and extend to the front of the PTFE cover plate.
Figure 11. Screw element in place