User Manual

FS- S E R I E S F O O T S E A L E R I N S T R U C T I O N M A N U A L

To install your replacement kit on your sealer, turn off power and unplug sealer.

Removing Worn Parts.

1. Loosen the screws on the PTFE cover plate (Figure 12, Item #C6-1/C6-2/C6-3). Remove the

heating element cover.

2. Lift up the PTFE cover to expose the heating element

(Figure 12, Item #D4-1/D4-2/D4-3).

Figure 7. Loosen screws on PTFE plate.

Figure 8. Pull PTFE cover to expose heating element.

3. Remove the heating element by unscrewing the element screw

(Figure 12, Item #12) (apply

pressure to the heating element with your finger while unscrewing the screw to prevent the

heating element from twisting).

4. Peel off the PTFE adhesive under the heating element.

Installing New Replacement Parts.

1. Remove the backing of the liner found on the PTFE adhesive.

2. Apply it to the sealer’s sealing platform. The PTFE adhesive must always extend past the sealing

platform by approximately ¼” to ½” on both ends. Bend down the excess on both ends. (The

PTFE adhesive acts a barrier between the metal body and the heating element. Never allow the

heating element to come in direct contact with the sealer’s body because it will damage the timer.)

3. Place a new element on top of the PTFE adhesive by screwing the element in the heating terminal

assembly block. To attach the element to the other side, lift the latch found on the heating

terminal block to push the block inward and securely screw the element to the block. Check the

elements to ensure it is tight and intact.