User Manual

FS- S E R I E S F O O T S E A L E R I N S T R U C T I O N M A N U A L
9
5. Connect the upper part of the pulling pole
(Figure 12, Item #F4) to the pulling plate/short
pulling pole
(Figure 12, Item #F8+F9). Gently push the upper jaw to meet the lower jaw.
Insert the cross bar at the end of the lower pulling pole
(Figure 12, Item #F3) into the notches
on the foot pedal. Please note: The length of the pulling pole can be adjusted with nut. To
lengthen, turn clockwise and to shorten, turn counterclockwise. Check the correct length of the
pulling pole by pressing down on the pedal. The upper and lower jaws should touch when the
foot pedal is pressed down. If not, please adjust the length.
6. Sealer is now ready to operate.
7. To install the optional working plate and table, remove the screws from bottom sealing jaw and
install the working plate and table.
Figure 4. Tighten the screws on base to secure foot pedal
Figure 5. Insert the short pulling pole through the small spring.
Figure 6. Attach pulling pole to the foot pedal.