User Manual

F R M - 1 1 2 0 C I N S T R U C T I O N M A N U A L
4
 Knurled pressure rolls with variable pressure adjustment
 PID digital temperature controller 0-300˚C (572˚F) with dual alphanumeric displays (target & current
temperature)
 Motorized rubber conveyor with speed control
 Capable of speeds up to 394 inches/minute
How Does the Band Sealer Work?
Our band sealers are comprised of a stainless steel frame, speed adjusting
mechanism, sealing temperature control system and transmission system. Turning
on the heat for the band sealer will cause a rapid rise in the temperature of the
heating blocks. Required temperature and speed can be adjusted via the
temperature controller and speed adjusting device. Plastic material to be sealed is
placed on the guide and conveyor. Conveyor will then take the material between the two heating blocks
to fuse the material together. Material will then pass through the cooling blocks to allow the material to
congeal. Finally, a photoelectric sensor will direct the dry ink coder to print a clear and legible print at the
seal line.
The motor drives the sealing belts, drive belts and conveyor simultaneously.
Specifications
FRM-1120C
FRS-1120W
Dry Ink Coding
Hot Stamp Printing
Power
110V/60Hz
Motor Power
100W
Sealing Speed
0-394 inches/minutes
Sealing Width
8mm
Temperature Range
0-300˚C (572˚F)
Conveyor Size
43” x 8”
Max Conveyor Load
16.5lbs
Printing Heating Power
40 x 2 (W)
50 x 2 (W)
Character Size
3x5x7mm / 18PT – 2 lines
2x3x7mm / 10.5PT – 3 lines
(additional option available)
2x4x15mm
Printing Colors
Black, Blue, Green, Red,
White, Yellow
Black, Blue, Red, White
Dimensions
43” x 24” x 41”
Weight
187lbs (n.w.) / 275lbs (g.w.)
Basic
Principles
FRM-1120C is easy to
use. To seal, adjust
temperature and place
bag on conveyor