User Manual

F R M - 1 1 2 0 C I N S T R U C T I O N M A N U A L
49
Figure 57. Default Setting Parameters
Figure 58. Parameter Displays
Printing Wheel Adjustments
Problem: Print wheel on the band sealer rotates more than once.
Possible Cause: Electromagnetic clutch on the back of the unit and groove sensor are not aligned properly.
The flat panel of the electromagnetic clutch signals the grove sensor to stop the print wheel rotation.
1. We suggest the following steps:
2. Loosen the nut as shown in Figure 59. This will allow the carbon brush holder and grove sensor
some movement.
3. Push the groove sensor closer to the electromagnetic clutch
4. Re-tighten the nut