User Manual

F R M - 1 1 2 0 C I N S T R U C T I O N M A N U A L

Figure 22. (1) Ink Roller, (2) Ink Roller Heating Block, (3) Swing Pole, (4) Adjusting Strut, (5) Ink Wheel Adjusting Device

7. Make Adjustments Between Printing Wheel and Silicone Wheel. The typesets/characters

on the printwheel should only touch the silicone wheel during the printing process. The

characters should not touch the silicone wheel at any other time. If the band sealer is used to seal

relatively thicker materials, the screw (Figure 23, Item #4) should be loosened. Rotate the

eccentric sleeve (Figure 23, Item #3) to ensure the characters/typesets slightly tough the silicone

wheel's surface. Refasten the screw after making adjustments.

Figure 23. (1) Printing Wheel, (2) Silicone Wheel, (3) Eccentric Sleeve, (4) Screw

8. Setting Printing Temperature. We recommend setting the ink temperature on the higher end.

Allow 5-10 minutes for the ink heating block and ink roller to reach the correct temperature.

Note: If band sealer is not in use right away, do not leave ink roller in the unit while temperature is on. This may

result in the ink roller melting and producing messy print.

9. Adjust Printing Position. The coding seat knob determines printing position on your material.

For example, if you want to print on the left side of your bag, turn the coding seat to its lowest