User Manual

F R M - 1 1 2 0 C I N S T R U C T I O N M A N U A L

4. Install Ink Roller into the Ink Roller Holder. Remove the metal ring found on the ink roller

holder using an allen wrench. Place the ink roller onto the ink roller holder and place the metal

ring back on the ink roller holder to hold the ink roller in place. Please note that for 30mm wide

ink rollers, the metal ring will not be used.

Figure 18. Remove metal wring found on the ink roller holder

Figure 19. Ink roller installed on ink roller holder

5. Insert Ink Roller in the Ink Wheel Heating Block. When inserting the ink roller, ensure the

ink roller lines up with the type on the printing wheel. If the ink roller is pushed in too far, the

printing wheel will not print correctly. Note: Do not allow the ink roller to heat continuously when machine

is not in use as heating block may melt the ink roller.

Figure 20. Correct Ink Roller Position

Figure 21. Incorrect Ink Roller Position

Test the ink roller position relative to the printing wheel. Place your finger under the

photoelectric sensor. The sensor light will turn green and allow the printing wheel to rotate.

6. Make Adjustments to Ink Wheel Adjusting Device. As the print wheel rotates, check that

the printing wheel makes contact with the ink roller. Make adjustments using the ink wheel

adjusting device (Figure 22, Item #5) if necessary. Turning the adjusting screw clockwise will

move the ink roller away from the print wheel and turning the adjusting screw counterclockwise

will move the ink roller closer to the print wheel.