User Manual

F R M - 1 1 2 0 C I N S T R U C T I O N M A N U A L
12
a. To set the temperature, press the button. The SV temperature will be displayed.
The SP light will be on to show the SV temperature.
b. Press the and button to change temperature setting.
c. Press the button to save the temperature settings.
d. Wait until the PV temperature matches the SV temperature which should take
approximately 5-10 minutes.
e. Check our YouTube channel (https://www.youtube.com/user/sealersales) for a video
demo.
f. Please note: Temperature will be in Celsius, not Fahrenheit. Do not attempt to make
additional adjustments to the temperature controller besides the temperature. The
temperature controller CANNOT be displayed in Fahrenheit and is ALWAYS in Celsius.
Please do not set the temperature controller above 200ºC. Please contact your local
distributor if you need assistance.
6. Adjust the pressure knob (Figure 34 , Item #71) on your band sealer depending on the
thickness of your bag material.
7. Place material on the guide (Figure 36, Item #28) and allow the band sealer to pull your
material through. Make sure your material is flat on the guide. While the material is moving
through the band sealer, do not push or pull the material as this will cause irregular sealing.
8. If the sealing belt is running off the guide wheels, make adjustments to the screws that are found
on the driven wheel seat (Figure 9, Item #1 & 2)
Figure 9. (1) Driven Wheel Seat (Adjusting Block), (2) Driven Wheel Seat (Adjusting Block), (3)/(4) Adjusting Screws, (5) Springs