User Manual

F R M - 1 1 2 0 C I N S T R U C T I O N M A N U A L

Installation

Important

Read this manual carefully, and make it available to everyone connected with the supervision, maintenance,

or operation of this machine. Additional copies are available at your request. (Contact your distributor for

this information.) Be very careful when operating, adjusting, or servicing this equipment. If in doubt, stop

and obtain qualified help before proceeding.

Installation

Place the band sealer in the desired location with the required electrical power source available. (See power

requirements.) Make certain that proper electrical wiring is provided to guard against low voltage. If the

voltage is too low, the equipment will not function properly.

Finding the proper location is a most important function of the initial set-up. One must take several factors

into consideration:

 Adequate power source

 Relationship to source of product

 Relationship to band sealer

 Relationship to any conveyors necessary to transport finished product

 Convenience of operator

1. Your new HL-M1120LD band sealer comes packaged in a heavy duty crate to protect it. If your

machine does not arrive in this condition, write on shipping paperwork that outside of box is

damaged. Concealed damage may have occurred.

2. Remove the nails.