Owner manual

9
Dometic Freshwater Tank Monitor Specifications
5.3 Dimensions
(g.
2
, page 2)
Ref. Dimension
A 83 mm / 3.25 in.
B 83 mm / 3.25 in.
C 51 mm / 2 in. clearance behind wall
D 10mm/0.38in.
Ref. Dimension
E 111 mm / 4.375 in.
F 25mm/1.0in.(ifapplicable)
G 527mm/20.75in.
H 69 mm / 2.75 in.
5.4 Approvals
ISO8846;EMCDirective2004/108/EC;CEapprovedforelectromagneticcompatibility
6 Installation
6.1 Tank Monitor Panel (g.
3
A, page 2)
Caution!
DonotinstallDTMF04panelinanatmospherewithpotentiallyammableorexplosive
vapors.
1. Select panel location away from direct contact with water
and oil.
2. Conrm clearance for wire connections behind wall, hull
liner or bulkhead.
3. Usingcontrolpaneltemplate(g.
6
, page 5), cut out panel
access hole (E, F) and drill fastener holes (G).
4. With electrical power off, route 18-gauge stranded copper
wire from power source, through circuit breaker or fuse (not
provided), to panel location. Route additional wire accord-
ing to diagram (g.
4
,page3–seewiringdiagramkey
below), depending on your application, to panel location.
Make sure wires extend out through access hole.
5. Make proper wiring connections to wires extending from
bottom of circuit panel (g.
3
A 2, page 3).
6. Remove panel cover (g.
3
A 1, page 3) from circuit panel/
mounting frame (A 2), if necessary, by carefully pulling them
apart.
7. Install mounting frame to wall with four fasteners (g.
3
A
3).
8. Pushpanelcoverontomountingframeuntilitlocks.
6.2 “Empty Tank” Shut-down Relay
(optional accessory) (g.
1
4, page 2)
1. At step 4 (above), route and connect 14-gauge stranded copper wires according to wiring diagram
(g.
4
, page 3) and wiring diagram key (see section 6.4).
2. Remove circuit panel housing from circuit panel (g.
1
5, page 2), and insert “Empty Tank” shut-
down relay into receptacle on back of circuit panel. Re-attach circuit panel housing.
DTMF04 Panel Template
Dimensions
(g.
6
, page 5)
Ref. Dimension
A 83 mm / 3.25 in.
B 83 mm / 3.25 in.
C 67 mm / 2.63 in.
D 67 mm / 2.63 in.
E 55 mm / 2.16 in.
F 68 mm / 2.69 in.
G 2mm/0.10in.dia.
H Cut-out area.
Allow 51 mm / 2 in.
clearance behind
wall.