User Manual

9
4.4 Approvals
ISO8846;EMCDirective2004/108/EC;CEapprovedforelectromagneticcompatibility
5 Components (g.
1
,page2)
Ref Description Item Number(NorthAmerica/Europe)
1 Replacement key 385311036 / 860003853110362
2 Switch assembly 385311610 / 860003853116104
3
DTD02panelcover,black
DTD02panelcover,white
385311674 / 860003853116740
385311675 / 860003853116757
4 #6 fastener 385311612 / 860003853116120
5 Mounting frame 385311613 / 860003853116138
6
DTD02circuitass’y,12VDC
DTD02circuitass’y,24VDC
(includesitem5)
385311676/860003853116765–12VDC
385311677/860003853116773–24VDC
6 Installation
6.1 Tank discharge control panel (g.
2
,page2)
DTD02 Panel Template
Dimensions (g.
8
,page5)
Ref. Dimension
A 3.25 in. / 83 mm
B 3.25 in. / 83 mm
C 2.63 in. / 67 mm
D 2.63 in. / 67 mm
E 2.16 in. / 55 mm
F 2.69 in. / 68 mm
G 0.10 in. / 2 mm dia.
H Cut-out area.
Allow2in./51mm
clearance behind
wall.
Caution!
DonotinstallDTD02panelinanatmospherewith
potentiallyammableorexplosivevapors.
1. Select panel location away from direct contact with water
and oil.
2. Conrm clearance for wire connections behind wall, hull
liner or bulkhead.
3. Usingcontrolpaneltemplate(g.
8
,page5),cutout
panelaccesshole(E,F)anddrillfastenerholes(G).
4. With electrical power off, route wire from power source,
throughcircuitbreakerorfuse(notprovided),topanel
location. Route additional wires from discharge pump,
seacockrelayand“fulltank”probeaccordingtodiagram
on page 3 or 4, depending on your application, to panel
location(seeSection6.2or6.3,wiringdiagramkey).Make
sure wires extend out through panel access hole.
5. Make proper wiring connections to wires extending from
bottom of circuit assembly (g.
2
4,page2).
6. Remove panel cover (g.
2
1,page2)frommounting
frame(2)bycarefullypullingthemapart.Makesurewiresbetweenkeyswitch(3)andcircuit
assembly(4)remainattached.(Keypin1–red;pin2–brown;pin7–blue)
7. Installmountingframetowallwithfourfasteners(5).
8. Tuck key switch wires into circuit assembly housing, and push panel cover onto mounting frame
until it locks into place.
9. Turn on electrical power.
Dometic Tank Discharge Control Specifications