Owner manual

7
6 Installation
1. Select panel location away from direct contact with
water and oil.
2. Conrm clearance for wire connections behind wall,
hull liner or bulkhead.
3. Usingcontrolpaneltemplate(g.8,page11),cutout
panelaccesshole(E,F)anddrillfastenerholes(G).
4. With electrical power off, route 14-gauge stranded copper
wire from power source, through discharge pump circuit
breakerorfuse(notprovided),topanellocation.Route
additional wire according to diagram on page 3 or 4
(seewiringdiagramkeysbelow),dependingonyour
application, to panel location. Make sure wires extend
out through access hole.
5. Make proper wiring connections to wires extending from
bottomofcircuitassembly(g.24,page2).
6. Removepanelcover(g.21,page2)frommounting
frame(2)bycarefullypullingthemapart.Makesurewires
betweenkeyswitch(3)andcircuitassembly(4)remain
attached.(Keypin1–red;pin2–brown;pin7–blue.)
7. Installmountingframetowallwithfourfasteners(5).
8. Tuck key switch wires into circuit assembly housing,
and push panel cover onto mounting frame until it
locks into place.
9. Turn on electrical power.
6.1 Tank Discharge Control Panel (g.2,page2)
Control Panel Template
Dimensions
(g.8,page11)
2
Dometic Tank Discharge Control Specifications
Caution!
Do not install DTD control panel in an atmosphere with potentially flammable or
explosive vapors.
Ref. Dimension
A 83mm(3.25in.)
B 83mm(3.25in.)
C 67mm(2.63in.)
D 67mm(2.63in.)
E 55mm(2.16in.)
F 68mm(2.69in.)
G 2mm(0.10in.)dia.
H Cut-out area.
Allow51mm(2in.)
clearance behind wall.
8
8
2
2
ISO8846;EMCDirective2004/108/EC
5.4 Approvals
5.3 Dimensions
(g.3,page2)
Ref. Dimension
A 83mm(3.25in.)
B 83mm(3.25in.)
3
Ref. Dimension
C 51mm(2in.)clearancebehindwall
D 10mm(0.38in.)
Maximumrelayratingfor12or24VDCdischargepump:20amps.
FloatSwitchRating:20wattswithresistiveload(whenusedwithDTM04system).