User guide
7
“DO NOT FLUSH” INDICATOR
A red “Do Not Flush” light indicate two possible toilet system conditions:
1. vacuum level in toilet system is not sufcient for complete ush.
2. holding tank is full and should be pumped out. When the red light is on,
electrical power to the toilet automatically shuts off to prevent possible overlling of
the holding tank.
4.5 Service mode
To clean the toilet bowl or perform other service that requires keeping the ush ball
open without running water, use the Service switch.
1. Push the Service button for three seconds. The steady backlight will change to
a ashing light while the toilet is in Service mode.
2. Perform the service operation. After the Service operation is complete, press
the Service buttom for three seconds to change back to normal toilet operation.
2 in. (51 mm) clearance
behind wall surface required
2.5 in. (64 mm)
2.25 in.
(57 mm)
2 in. (51 mm) clearance
behind wall surface required
1.875 in. (64 mm)
2 in.
(51 mm)
VFP and DFP
WALL BRACKET
VFP and DFP
WALL BRACKET
VFS and DFS
WALL BRACKET
5 Flush Switch
Wall Templates
Note
See important information
on back page before using
either template.