User guide
6
4 VacuFlush Toilet Operation with
VFS or VFP Flush Switch
4.1 Toilet system start-up
1. Turn on electrical power and water supply to toilet.
2. Flush water through entire toilet system by ushing toilet ve
times (press “Flush” switch and allow each ush cycle to
complete until green light indicates system is ready for next
ush). Each cycle takes about one minute.
4.2 Normal toilet operation
ADD WATER TO TOILET BOWL (and panel backlighting function)
Press “Add Water” switch until desired water level is achieved. More water is usually
added only when ushing solids. (If switch is pressed too long, water ow will shut
off automatically to avoid overow.)
BACKLIGHTING: To turn switch backlighting effect off or on, push “Add Water”
switch twice very quickly.
FLUSH TOILET
Press “Flush” switch down for a moment, then release it. Flush only when the green
“OK to Flush” light is on. Toilet will not ush until the green “OK to Flush” light is on.
It takes about one minute for vacuum to recharge for the next ush.
If the red “Do Not Flush” light is on, the system is either recharging the vacuum, or
the holding tank is full. Do not attempt to ush the toilet during these conditions, or a
clog may occur in the toilet system.
DO NOT FLUSH FOREIGN OBJECTS
CAUTION! Flush only water, bodily wastes and rapid-dissolving tissue paper. Do not
ush wet wipes, sanitary napkins, condoms, diapers, razor blades paper cups,
cotton swabs food, hair or liquids such as oils or solvents. Clogging or damage to
the toilet system may occur.
Note
Make sure all guests understand toilet operation before use.
4.3 Changing flush modes
SeaLand VacuFlush all-ceramic toilets offer two ush settings to help manage water consumption:
Normal flush – Uses 1 quart (0.95 liter) per ush. Adds water to bowl after every ush.
Dry Bowl flush – Uses 1 pint (0.5 liter) per ush. Does not add water to bowl after ush.
To change from Normal to Dry Bowl ush setting, press “Flush” switch for about ve seconds. When
green “OK to Flush” light on status panel begins ashing, release “Flush” switch. Flush mode has
been changed to Dry Bowl setting. Change mode to Normal ush by following the same procedure.
4.4 Indicator lights
“OK TO FLUSH” INDICATOR
A steady green “OK to Flush” light indicates when the toilet is ready to ush. A
momentary ashing green light indicates when ush mode is changing.
(continued on next page)