Installation

9
5. Plan ush switch panel and electronic control module loca-
tions so that electrical connections can be made with cables
provided with toilet. Be sure module and wires cannot get wet.
Note
Several ush switch options are available from Dometic.
Instructions for installing the Dometic ush touchpad (DFT)
follow. Other available types t either Vimar or Gewiss ush
switch/status panel components. Instructions for these are
included with each ush switch assembly.
6. Use Dometic DFT touchpad template to mark location of
fastener and access holes. Drill 1 in. (25 mm) hole, then
fasten panel bracket to wall (g.
12
).
7. Route Dometic touchpad cable (g.
1
E,
p. 2) from ethernet connector on control module
to access hole at touchpad panel location. Attach
cable to touchpad panel, then snap the panel
cover onto the panel bracket (g.
12
).
8. Install control module in cool, dry location
and attach Dometic touchpad cable to ethernet
connector on control module (g.
13
, p. 10).
9. With electrical power off, complete wiring con-
nections to control module. Refer to wiring dia-
gram printed with parts list (packed separately).
10. Route 4-wire control module cable (g.
1
D,
p. 2) to toilet through access hole in oor.
Caution! Hazard of Flooding
If toilet uses raw water for ushing at ANY time, a raw water pump controlled by an automatically operat-
ing demand switch MUST NOT be installed. If the onboard water valve or any plumbing connections
were to leak, the automatically operated pump would start and could ood the boat. Failure to comply
with this warning can cause loss of property and life.
5.3 Toilet system with through-the-floor connections
1. Place oor mounting template in desired location (g.
10
).
For optimal user comfort, make sure walls or other interior
xtures are at least 11 in. (279 mm) away from centerline of
template.
2. Center punch all holes and mounting bracket corners
through template.
3. Remove template from oor. Drill all access and fastener
holes as indicated on template. DO NOT drill mounting
bracket corners.
4. With long hex-head screws from toilet oor bracket kit,
fasten oor brackets with 3/8 in. (10 mm) socket wrench,
using corner marks as guides (g.
11
).
12
10
11
Note
Do not completely tighten hex-head screws to oor – allow
brackets to slightly slide. Brackets will tighten when fastening
toilet to brackets.
SeaLand MasterFlush Toilet Installation