Installation

10
15. Position toilet over oor
brackets and tilt toilet up
from back. Push discharge
assembly tting and hose up
into discharge loop outlet,
and tighten band clamp
(g.
17
).
16. Lower toilet down so that
oor brackets show through
fastener holes (g.
18
).
17. Turn on water supply and
electrical power to toilet,
and check for leaks. Press
“Flush” switch (g.
3
2,
page 2). If leak occurs,
tighten connection.
18. Insert plastic adapters from
Floor Bracket Kit into fas-
tener holes. Fasten toilet to
brackets with short screws
provided in kit.
19. Cover oor bracket screws
with plastic covers (g.
19
).
11. Route water supply and discharge plumbing to toilet according to system requirements (Section
4.2). Make sure to provide extra discharge hose length to assure easy connection to toilet
(g.
14
).
12. Loosen band clamp on discharge loop outlet and remove discharge adapter tting/hose
tting assembly (g.
15
).
13. Lubricate discharge tting assembly and inside end of discharge hose with liquid dishwashing
soap. Push discharge tting assembly into discharge hose and connect with two hose clamps.
Be sure to position hose clamp screws 180° apart from each other (g.
16
). Place toilet near
access holes and oor brackets.
14. Connect toilet water line to water supply line and 4-pin connector to control module cable.
13 14
17
18
19
16
15
Installation SeaLand MasterFlush Toilet