Installation Manual

9
11.Loosenbandclampondischargeloopoutletandremovedischargeadaptertting/hose
ttingassembly(g.
13
) .
12.Lubricatedischargettingassemblyandinsideendofdischargehosewithliquiddishwashing
soap. Push discharge tting assembly into discharge hose and connect with two hose clamps.
Besuretopositionhoseclampscrews180°apartfromeachother(g.
14
).Placetoiletnear
accessholesandoorbrackets.
13. Connect toilet water line and 4-pin connector to water supply line and control module cable.
14.Positiontoiletoveroorbracketsandtilttoiletupfromback.Pushdischargeassemblytting
andhoseupintodischargeloopoutlet.Lowertoilettooorandtightenbandclamp(g.
15
).
15.Turnonwatersupplyandelectricalpowertotoilet,andcheckforleaks.Press“Flush”switch
(g.
4
2,page2).Ifleakoccurs,tightenconnection.
16.Atoormountingholes,drillpilotholesforhex-headoorfasteners.Installfastenersand
washers using a 3/8in.(10mm)socketwrench(g.
16
).
17.Coveroorfastenerswithplasticcovers(g.
17
).
Dometic 8700 Series MasterFlush Toilet Installation
12
15
16 17
14
13