Installation Manual

8
Dometic 8700 Series MasterFlush ToiletInstallation
5.3 Toilet system with wall touchpad and through-the-floor connections
- all applications
1. Placeoormountingtemplateindesiredlocation(g.
8
).Foroptimalusercomfort,makesure
wallsorotherinteriorxturesareatleast11in.(279mm)awayfromcenterlineoftemplate.
2. Center punch all holes through template.
3. Removetemplatefromoor.Drillallaccessholesasindicatedontemplate(g.
9
).
4. Planushswitchpanelandelectroniccontrolmodulelocationssothatelectricalconnectionscan
bemadewithcablesprovided.Besuremoduleandwirescannotgetwet.
5. UseDometicwallswitchtemplatetomarklocationoffastenerandaccessholes.Drill1in.
(25mm)hole,thenfastenpanelbrackettowall(g.
10
).
6. RouteDometicushswitchpanelcablefromcontrolmoduletoaccessholeatushswitchpanel
location.Attachcabletoushswitchpanel,thensnapthepanelcoverontothepanelbracket
(g.
10
).
7. Installcontrolmoduleincool,drylocation,thenattachDometicushswitchcabletocontrol
module(g.
11
) .
8. With electrical power off, complete wiring connections to control module. Refer to Section 5.6,
Wiring schematic - Dometic flush touchpad or Vimar/Gewiss controls.
9. Route4-wirecontrolmodulecable(g.
1
D,page2)totoiletthroughaccessholeinoor.
10.Routewatersupplyanddischargeplumbingtotoiletaccordingtosystemrequirements(Section
4.2).Makesuretoprovideextradischargehoselengthtoassureeasyconnectiontotoilet
(g.
12
,page9).
8
9
10
Note
WheninstallingVimarorGewissushswitch/statuspanel,
disregardinstructionsforinstallingDometictouchpadswitch.
Install Vimar or Gewiss component on wall according to
manufacturer’sinstructions,thenattachendofcableto6-wire
connector(g.
1
D,page2)atcontrolmodule.
11