Installation Manual

10
Dometic 8700 Series MasterFlush ToiletInstallation
5.4 Toilet system with flush handle and through-the-floor connections
- all applications
1. Follow steps 1-3 in Section 5.3.
2. Plan electronic control module and status panel locations so that electrical connections can be
madewithcablesprovided.Besuremoduleandwirescannotgetwet.
3. UseDometicwallswitchtemplatetomarklocationoffastenerandaccessholesforstatuspanel
(g.
1
M,page2).Drillwiringaccesshole,thenfastenpanelbrackettowall.
4. Routeushhandle/statuspanelcable(g.
1
N,page2)fromcontrolmodulelocationtotoilet
andstatuspanel.RouteDometicushhandlecablesection(withorangeconnector)toaccess
hole at toilet location. Route other section of cable through status panel access hole and
connect to status panel wire. Attach status panel to panel bracket on wall.
5. Installcontrolmoduleincool,drylocation,thenattachDometicushswitch/statuspanelcable
tocontrolmodule(g.
18
) .
8. With electrical power off, complete wiring connections to control module. Refer to Section 5.7,
Wiring schematic - Dometic flush handle and status panel.
9. Route4-wirecontrolmodulecable(g.
1
D,page2)totoiletthroughaccessholeinoor.
10.Routewatersupplyanddischargeplumbingtotoiletaccordingtosystemrequirements(Section
4.2).Makesuretoprovideextradischargehoselengthtoassureeasyconnectiontotoilet
(g.
19
) .
11. Follow steps 11-13 in Section 5.3 to connect discharge plumbing and 4-pin connector at toilet.
12.Connect3-pinushhandlecableconnectorto3-pinwirefromcontrolmodule(g.
20
) .
13.Followsteps14-17fromSection5.3tonishinstallationandtesting.Pressushhandledown
when testing operation and checking connections.
18
20
19