User Manual

7
Dometic 8700 Series MasterFlush Toilet Operation
6.1 Toilet system start-up
1. Turn on water supply to toilet.
2. Press“Flush”switch(g.
4
2)once.Afterninesecondsofwaterow,maceratorpumpwillstart
and run for about six seconds to clear bowl. It will take about ve seconds to rell bowl.
3. Toss several sheets of toilet paper into bowl and repeat
cycle. The bowl should completely clear.
6.2.1 Normal toilet operation -
Dometic touchpad or other wall switch
ADDING WATER TO TOILET BOWL
Press“AddWater”switch(g.
4
1) until desired water level
isachieved.(Waterowwillshutoffautomaticallyifswitch
ispressedtoolongtoavoidoverow.)Morewaterisusually
addedonlywhenushingsolids.
FLUSHING TOILET
Press“Flush”switch(g.
4
2), then release it. This activates a powerful
macerator pump that siphons water and waste from the bowl, macer-
ates,andpropelstheefuentthroughthedischargelinetotheholding
tank.
6 Operation
Caution – Do Not Flush Foreign Objects!
Flush only water, bodily wastes and rapid-dissolving toilet
tissue.Donotushwetwipes,sanitarynapkins,condoms,
diapers,papercups,cottonswabs,food,hairorliquids
such as oils or solvents as clogging or damage to the toilet
or toilet system may occur.
Note
Make sure all guests understand toilet operation before use.
6.2.3 Indicator lights
“POWER ON” INDICATOR
OntheDometicushswitchpanel,asteadygreen“PowerOn”light(g.
4
3) indicates when
electricalpowertothetoiletisactivated.Amomentaryashinggreenlightindicateswhenush
mode is changing.
“FULL TANK” INDICATOR
TheDometicushswitchpanelincludesared“FullTank”light(g.
4
4) to indicate when the holding
tank is full (if connected to a tank monitoring system) and should be pumped out. When the red light is
illuminated, electrical power to the toilet automatically shuts off to prevent overll of the holding tank.
6.2.2 Changing flush modes
Dometic8700seriesMasterFlushtoiletsoffertwoushsettingstohelpmanagewaterconsumption:
Normal flush–Uses0.85gal.(3.2liters)perush.Addswatertobowlaftereveryush.
Dry Bowl flush–Uses0.45gal.(1.7liters)perush.Doesnotaddwatertobowlafterush.
TochangefromNormaltoDryBowlushsetting,press“Flush”switchforaboutveseconds.When
“PowerOn”light(g.
4
3)beginsashing,release“Flush”switch.Flushmodehasbeenchangedto
DryBowlsetting.ChangemodetoNormalushbyfollowingthesameprocedure.
4
1
2
43