Installation Instruction Manual

9
11. Connect water valve adapter to exible water line with hose clamp (g.
10
).
12. Securely connect water valve adapter to water valve tting (g.
11
).
13. Loosen band clamp on discharge loop outlet and remove discharge adapter tting/hose
tting assembly (g.
12
).
14. Lubricate discharge tting
assembly and inside end of
discharge hose with liquid
dishwashing soap. Push dis-
charge tting assembly into
discharge hose and connect
with two hose clamps. Be
sure to position hose clamp
screws 180° apart from each
other (g.
13
). Place toilet
near access holes.
15. Connect ush switch panel
wires to toilet wires
(g.
14
) according to appro-
priate wiring diagram (pp. 11-
12). Connect ground wires
from toilet as indicated.
16. Position toilet over oor
brackets and tilt toilet up
from back. Push discharge
assembly tting and hose up
into discharge loop outlet,
and tighten clamp (g.
14
).
17. Lower toilet down so that
oor brackets show through fastener holes (g.
15
).
18. Turn on water supply and electrical power to toilet, and check for leaks. Press “Flush” switch
(g.
4
1, page 2). If leak occurs, tighten connection.
19. Insert plastic adapters from Floor Bracket Kit into fastener holes. Fasten toilet to brackets with
short screws provided in kit.
20. Cover oor bracket screws with plastic covers (g.
16
).
Dometic 8100 Series MasterFlush Toilet Installation
15
16
11
10
12
13
14