User guide
7
VacuFlush Pedal-Flush Toilet Operation
6 Operation
6.1 Toilet system start-up
1. Fill freshwater tank.
2. TurnonelectricalpowerandwatersupplytoVacuFlushtoiletsystem.
3. Flushwaterthroughentiretoiletsystembypressingushpedalforabout15seconds.
Releasepedal,allowingpedaltosnapbackintooriginalposition.Vacuumpumpwilloperatefor
about one minute, then shut off.
6.2 Normal toilet operation
ADD WATER TO TOILET BOWL
Liftushpedaluntildesiredwaterlevelisachieved.Morewaterisusuallyadded
onlywhenushingsolids.(Ifpedalisraisedtoolong,toiletbowlcanoverow.)
FLUSH TOILET
Pressushpedaldownforabout3seconds,thenreleaseit.Allowpedaltosnap
back into original position to assure vacuum seal. It takes about one minute for
vacuumtorechargeforthenextush.Asmallamountofwaterremainsinbowl
aftereveryush.
Ifushpedalisaccidentallyreleasedbeforeefuentleavesbowl,donotushagain
until vacuum pump stops running.
DO NOT FLUSH FOREIGN OBJECTS
CAUTION! Flush only water, bodily wastes and rapid-dissolving tissue paper.
Donotushwetwipes,sanitarynapkins,condoms,diapers,razorblades,paper
cups,cottonswabs,food,hairorliquidssuchasoilsorsolvents.Cloggingor
damage to the toilet system may occur.
Note
Make sure all guests understand toilet operation before use.
6.3 Indicator lights (requires optional VacuFlush status panel)
“OK TO FLUSH” INDICATOR
OnaVacuFlushstatuspanel,asteadygreen“OKtoFlush”lightindicateswhenthetoiletisready
toush.
“DO NOT FLUSH” INDICATOR
VacuFlushstatuspanelsincludeared“DoNotFlush”lighttoindicatetwotoiletsystemconditions:
1. vacuumlevelintoiletsystemisnotsufcientforcompleteush.
2. holding tank is full and should be pumped out (only when connected to an optional holding
tank level indication system). When the red light is on, electrical power to the toilet automatically
shuts off to prevent possible overlling of the holding tank.
(continued on next page)