Owner's manual

STEP 9: WITH THE ELECTRICAL POWER OFF, route

#14 gauge stranded copper wire from 12 VDC ground

and positive 12 VDC from the fuse panel through a 7- or

8-amp fuse or circuit breaker. Leave at least 30 inches

(762 mm) of wire for connecting to toilet (g. 9).

STEP 10: Connect the holding tank to the bottom of the

discharge ange.

STEP 11: Slide the four T-bolts into the slots of the oor

ange. Install the ange gasket over the T-bolts (g.

10).

Fig. 9

Fig. 10

STEP 12: Install oor ange adapter with words “THIS SIDE

UP” facing up. Tighten adapter to oor ange using four

at washers and hex nuts. Tighten in criss-cross pattern

(g. 11).

STEP 13: Temporarily set the toilet in place on the oor

ange (g. 14).

STEP 14: Mark the holes for the two toilet mounting

bolts (g. 15).

Fig. 16

STEP 15: Pick up toilet and set aside. Drill 3/16-inch

pilot holes in the oor (g. 16).

Fig. 15

Fig. 14

Fig. 11

IMPORTANT: If replacing an existing toilet that uses

a 2-bolt oor ange, drill two 5/16-inch dia. holes in

old oor ange that align with two additional holes

in oor ange adapter. Use two #10 or 12 x 1-1/2-inch

wood screws and washers for these drilled holes,

and two T-bolts with at washers and nuts to fasten

ange gasket and oor ange adapter to old oor

ange. Do not use old hardware or seal.

FOR MODEL 3400 TOILET

WITH REMOTE SWITCH

OPERATION, see page 7

for wall switch installation

instructions.