Owner's manual

STEP 5a: For through-the-oor water line and electrical

wires, mark another centerline 6 inches (152 mm) from

the back wall (g. 4).

STEP 5b: For through-the-wall water line and electrical

wires, mark a centerline 8 inches (203 mm) up from the

oor centerline (g. 5).

STEP 6: Make a 4-3/4 inch (121 mm) diameter hole (for

most oor anges) or a 5-1/8 inch (130 mm) diameter

hole (for swivel joint oor ange) at the centerline mark

furthest from the wall. Make a 1 inch (25 mm) hole at the

mark closer to the wall for the water line and electrical

wires (g. 6).

STEP 7: Insert oor ange into larger hole and secure

to the oor with #12x3/4-inch long at head wood or

sheet metal screws (g.7).

Fig. 5

Fig. 6

Fig. 4

IMPORTANT: The prefered oor ange installation

method is to mount the oor fIange directly on the

nished oor. However, if the bottom of oor ange

and bottom of ceramic toilet must be mounted at

different heights, the oor ange must be mounted

within 3/8 inch (10 mm) of the bottom of the toilet (see

illustrations in next column) or leakage may result.

Below-Floor Installation

STEP 8: Route 1/2-inch (13mm) PEX tubing through

the smaller hole and install a PEX 1/2-inch MPT tting

(g. 8).

NOTE: A water shut-off valve should be installed in the

water line to the toilet for maintenance requirements.

Fig. 7

Above-Floor Installation

Fig. 8