Owner's manual

TROUBLESHOOTING (cont’d)

SYMPTOM 6. Water will not stay in bowl.

Condition/Procedure

Put Mode Switch in “Service”

position:

Worn or damaged ush valve ball

and seal:

Corrective Action

• Clean underside of ush valve ball seal of dirt and debris.

• Remove toilet from oor and remove base assembly from toilet and

replace ush valve ball and seals.

SYMPTOM 7. Water will not shut off and overows the toilet.

Procedure

Check the “WATER VALVE” status

light:

Corrective Action

• If the light is on when not ushing the toilet or adding water, replace

the control module. If the light responds correctly, go to next step.

• Dirt or debris lodged in the water valve seal. Remove the toilet from

the oor, disassamble and clean water valve.

• Replace water valve.

SYMPTOM 8. Water is leaking from under the toilet.

Procedure

Remove the toilet from the

oor and inspect the following

with both water and electrical

power applied:

(Place a container under the base

assembly to catch any water during

the inspection procedure.)

• Water hoses and ttings, water valve assembly

• Ceramic toilet bowl

• Upper base seal

• Flush valve ball rotor shaft shaft

• Base assembly