Owner's manual
10
The SeaLand toilet should be cleaned regularly for maximum sanitation and
operational efciency. You can clean it just as you would a household toilet.
Do not use caustic chemicals, such as drain-opening types, as they will
damage the seals.
BOWL CLEANING: For stubborn stains, use SeaLand Toilet Bowl Cleaner (Fig.
A). It’s manufactured especially for use with SeaLand toilets. In certain locations
where water is hard, a build-up of lime may dull the toilet bowl nish. Restore
the shine with this cleaner. If you cannot nd our brand in your area, contact
SeaLand Product Customer Service for your nearest dealer. If it is not available,
you can also use Bar Keepers Friend
®
cleanser. It is not necessary to vigorously
scrub with either product. Please follow label instructions.
SEAL CLEANING: After an extended time, mineral deposits from hard water
can build up under the edge of the rubber bowl seal, resulting in a slow leakdown
of water from the bowl. To prevent this mineral build-up, periodically clean under
the bowl seal with SeaLand Toilet Bowl Cleaner (Fig. B).
1. Put Mode switch in SERVICE position. Flush ball will open automatically.
2. Apply cleanser onto a cleaning tool (small brush, etc.), and scrub under the
seal. Make sure to push bristles between bottom of seal and top of ush ball
surface to scrub all parts of seal that come into contact with ush ball.
3. Wait 2-3 minutes.
4. Pull up on ush handle or push "Add Water" switch to let water ow into
bowl. Use cleaning tool and water to rinse away cleanser and loosened deposits. You can add water for up to
15 seconds in the SERVICE position.
5. Put Mode switch in NORMAL position. Water will ow for a few seconds, then ush ball will close automatically.
Water will continue owing into bowl, making it ready for the next ush.
Fig. B
PROPER CLEANING – TOILET BOWL AND SEAL
Fig. A
MANUAL FLUSH OPERATION
In the event of an electrical failure, the ush ball of the toilet can be manually opened to clear the bowl. We recom-
mend using a long-neck screwdriver or 7/16-in. socket for the operation shown below. NEVER PRY OPEN THE
FLUSH BALL FROM INSIDE THE TOILET BOWL. Damage to the ush ball and bowl seals may result.
1. Remove access cover from top of ceramic toilet. Place
Mode Switch in the "Manual Override" position. This dis-
connects ush valve motor brake from electrical circuit.
2. Locate hole on side of ceramic toilet. This allows access
to the ush valve motor drive arm.
3. Insert screwdriver or 7/16-in. socket through access hole
and onto hex head.
4. Turn screwdriver or socket counter-clockwise. This will
open ush ball and allow bowl contents to clear. After
bowl is clear, turn screwdriver or socket clockwise to
return ush ball to original position.
NOTES:
Water will not enter the toilet bowl during manual ush
operation.
Place Mode Switch in the "Normal" position before return-
ing to automatic operation.
Manual Override
position
® Bar Keepers Friend is a registered trademark of SerVaas Laboratories Inc.