Manual

Dometic Gravity-Flush Toilet Installation

6 Installation

Note

Be sure foot pedal, when pressed, touches same at surface on which toilet is installed.

Note

Be sure to follow recommended installation requirements in section 4.2 of this manual.

6.1 Tools required

• pliers or adjustable wrench

• 7/16-in. / 11 mm wrench

6.2 Toilet installation

1. To replace an older toilet, turn off water supply to toilet. Remove and drain water supply line.

Remove toilet hold-down bolts/screws. Remove toilet from oor. Remove and discard old

oor ange seal and hold-down bolts. Verify center of oor ange is at least the recommended

rough-in distance from back wall (g.

A, p. 3) for your toilet model (see Rough-in dimensions

chart). Make sure top surface of oor ange is clean and free of any debris or sealant.

2. If installing a new oor ange, make certain that toilet mounting holes are located at the correct

angle (g.

D, p. 3). Floor ange must be secured to oor with a minimum of four screws

(8 is preferred). Insert two supplied T-bolts into slots in oor ange (g.

p. 3).

3. Verify that oor ange seal is installed on base of toilet (g.

A, p. 3). Carefully set toilet over

oor ange. Align holes in toilet base with T-bolts as toilet is lowered onto oor ange. Toilet

must be aligned so that outlet of base ts inside of oor ange outlet hole.

Note

Entire toilet base does not rest completely on oor yet. Floor seal must be compressed in

following steps.

4. Install oor mounting nuts and washers onto T-bolts. Carefully torque nuts to 30-40 inch-

pounds. DO NOT OVERTIGHTEN. Alternate between sides when tightening to prevent

distortion of base. When tight, base should be securely attached and at against oor.

Attach bolt covers onto nuts. (Fig.

B, p. 3)

5. If toilet is being installed in a shower stall, apply a bead of caulk around base of toilet to prevent

water seepage under base.

6. Connect water supply line and torque connection to 30-40 inch-pounds.

DO NOT OVERTIGHTEN. (Fig.

C, page 3)

7. Turn on water supply line. Flush toilet several times and check for leaks.