Owner`s manual

ManualsBrandsSeaLand ManualsVacuum Cleaner1 2500 Series

OPERATION

DISPLAY PANEL.

START-UP CHECKLIST

Before rst-time use of the 2500 series sanitation

system, check the following:

• The vacuum cassette tank is inserted correctly.

• The fresh water supply tank is full.

• The power supply is on.

GREEN – Ready to ush.

RED – Cassette full, or cassette

removed, or undervoltage.

Toilet cannot be ushed.

YELLOW – Vacuum pump is running.

Do not ush toilet.

LED

Flush toilet only when

green LED is illuminated.

Never ush toilet while

sitting on open toilet seat,

or if the seat lid is up.

Do not ush any solid or

non-dissolving objects

such as paper towels,

plastic cans. They can

plug or damage system.

The yellow LED illuminates for about one minute.

Then the green LED illuminates.

THE SYSTEM IS READY FOR OPERATION.

FLUSHING THE TOILET

1. Make sure there is enough water in the bowl to

cover the ush ball and seal in bottom of bowl. Lift

pedal to add water to bowl (if needed for ushing

solids).

2. To ush, press pedal down to oor and hold down

for 2 or 3 seconds. Keep seat lid closed to reduce

noise.

3. The toilet will ush liquids effectively with only

1 pint (0.4 liters) of water per ush.

4. Use only rapid-dissolving toilet paper designed

for low water ow toilets. Some residential bath

tissues may clog the system.

5. If the cassette tank is full, the

tank is removed from the docking

platform, or the voltage is too low,

the red LED illuminates and the

system switches off. The system

cannot be used until the cassette

is emptied, inserted properly in the

docking platform, and the correct

voltage is restored.

REMOVING CASSETTE TANK

(model 2510)

1. Raise the latch (A). Holding the carrying

handle (B), pull cassette straight back.

2. When reattaching cassette tank, make sure

it is placed correctly on docking platform.

Make sure latch engages after pushing tank

into platform.