Specifications

8
UNPACKING, SET-UP AND INSTALLATION
UNPACKING YOUR LAMINATOR
Remove the transport packing and the plastic
shrink-wrap the laminator is wrapped in to avoid
moisture penetration.
Remove the accessory kit package from the top of
the laminator, which includes the necessary tools
for installation.
Remove the footswitches from the top of the
laminator and remove the foam wrapped around
them. Place a footswitch on each side of the
laminator for operator use while feeding images.
Remove the front and back tables (in cardboard
boxes) from the top of the laminator. Remove the
tables from the cardboard boxes and set them aside.
Remove the protective foam wrapped around the
front and back table arms.
Follow the Installation Instruction sheet in the
accessory pack to reattach the table arms.
Once reattached, insert the tables into position.
Remove the roll easel shaft from the crate and
remove the packing wrap.
Place the roll easel shaft into the table receivers and
lock into place.
The top rollers will go up automatically when air is
connected.
Remove the foam placed between the top and
bottom rollers.
Remove the stickers securing the protective paper
on the rolls using your fingers only.
Then gently pull the paper towards you to unwind
off the roll.
WARNING! DO NOT USE OPEN BLADES
TO REMOVE THE PROTECTIVE PAPER
ON THE ROLLERS.
Roller damage caused by improper use of cutting
tools will void the user’s warranty. Small cuts and
imperfections in the rollers greatly affect the quality
of the output and roller replacement costs are
expensive.
LEVELING YOUR LAMINATOR
Thread the leveling feet included in the accessory
pack onto each of the four transport bolts located
in the corners of the cabinets. Tighten securely.
Use the ½” wrench to turn the transport bolts
down until the leveling feet are positioned flat
against the floor.
Insert a 3’ x 1’ (91cm x 30cm) piece of foam board
across the two center chill idlers and place the level
in the center on top of this foam board.
Adjust the leveling feet for each side cabinet until
level.
Next, place the level on the tops of each of the
cabinets lengthwise and adjust the leveling feet from
the front to the rear of the cabinet as needed.