Specifications

31
PROCESS CONTROL SHEET
NOTE: We recommend that you make a photocopy of this page. With each successfully run application,
record the process and settings and a diagram of the webbing procedure. Keep the record so the application
can be repeated at a later date.
HINT: If a standard image is made available for each new process then sales materials and samples can be
developed for reference.
LAMINATOR SETTINGS
Media: ____________________________________
Process: ___________________________________
Application Use: _____________________________
Top Unwind Shaft: ___________________________
Bottom Unwind Shaft:_________________________
Front Control Panel Settings
Top Roller Temp: ___________________________
Bottom Roller Temp: _________________________
Main Roller Pressure:__________________________
Cooling Fan: On / Off ________________________
Back Control Panel Settings
Pull Rollers: Up / Down _______________________
Pull Roller Pressure: __________________________
Pull Clutch Tension: __________________________
Motor Control Panel Settings
Motor Direction: Forward / Reverse_______________
Motor Speed Setting: _________________________
WEBBING SETTINGS
Chill Idlers: [Over/Under] 1st / 2
nd__________________________
Web Tension Top Unwind Shaft:
Light / Med. / Heavy _________________________
Web Tension Bottom Unwind Shaft:
Light / Med. / Heavy _________________________
Shim Wheel Settings: Front / Back ________________
Images: Sheet Fed / Roll Easel ___________________
Top
Main Roller
Top
Pull Roller
Front
Top
Supply
Rear
Top
Supply
Bottom
Main Roller
Bottom
Pull Roller
Chill
Idler
Shim Wheel
Print Guide
Front Table
Shim Wheel
Covere
d
Foot
Switc
h
Front
Chill
Idler
Rear
Front
Bottom
Wind -up
Rear
Bottom
Wind-up
Rear
Bottom
Supply
Shaft
Front
Bottom
Supply
Shaft
Rear
Roll
Easel
Front
Roll
Easel
Rear Top
Wind -up
Front Top
Wind-up
Top
Idler
Rear Table
Covere
d
Foot
Switch
Fan
Tub
Fan
Tub
e
Bott
Idler
Bott
Idler