Specifications

19
TABLE OPERATION
PIVOTING TABLE USE FOR WEBBING
First, remove the roll easel shaft from its brackets
and set aside.
Pull out both retaining plungers of the roll easel
brackets and pivot the brackets down and forward
as shown in Figure 12.
Figure 12. Pivoting Roll Easel Bracket Down
Remove the top and bottom wind-up idlers for easy
webbing and set them aside.
On the right-hand side of the table, pull out the
locking retaining plunger and turn sideways to lock
with plunger recessed (see Figure 13).
Move to the left side and pull out the non-locking
retaining plunger on the left-hand side of the table.
Allow the table brackets to slide outwards and
down.
Grasp the front edge of the table and lifting up
pivot the table towards you, away from the rollers
(see Figure 13).
Figure 13. Releasing Retaining Plunger
Reach through the opening between the table and
rollers and pull the bottom film up and pass it
behind the bottom idler.
Pull the film up and place it over the top roller.
Reposition the table by lifting the outer edge
upwards and pivot in towards the roller (Figure 14).
Figure 14. Table Pivoting Up
With the table resting on the table bracket
standoffs, lift the outer edge of the table and push
the table in towards the roller (see Figure 15).
Figure 15. Pivoting Table Forwards
The non-locking retaining plunger will catch
automatically.
Moving to the right hand side of the table release
the locking retaining plunger so it locks in place.
The table operation is the same front and rear.