Specifications

16
CHECKING OPERATION
After you are familiar with the control panels
and their functions, check all operations.
CHECK THE MAIN POWER
• Press the Stand-by switch up and the front and back
displays on the control panels should be lit.
• The center red switch on both top cabinet control
panels should be illuminated.
CHECK THE EMERGENCY STOP BUTTONS
• Press one of the Emergency Stop Buttons and the
laminator will shut down.
• Rotate the Emergency Stop Button clockwise to
reset.
• Repeat this procedure with all four Emergency Stop
Buttons.
CHECK THE HEATER CONTROLS
• Press the Top Heater On/Off button once; the
corresponding LED should be lit.
• The readout will display the ambient temperature.
• Press and hold the top heater Up Arrow to increase
the temperature set point. Watch the readout for 5
minutes to verify that the temperature increases.
• Press and hold the Down Arrow to decrease the
temperature set point.
• Press the top heater On/Off button again once; the
corresponding LED should not be lit.
• Repeat this procedure for the Bottom Heater.
CHECK THE MOTOR AND FOOTSWITCHES
Check both motor control panels as follows:
• Push the green Motor Forward Switch and the
rollers should rotate in the forward direction.
• Press the green Motor Reverse Switch and the
rollers should rotate in the reverse direction.
• As you turn the speed control knob clockwise the
speed of the rollers should increase and the speed
readout (top display on front and rear control
panels) should increase in number.
• Turning the speed control knob counter-clockwise
should decrease the speed of the rollers and the
speed readouts should decrease in number.
• Press the center red Motor Stop Switch and the
rollers should stop rotating.
• Press the footswitch and the rollers should rotate in
whichever roller direction that was last pressed.
Check both footswitches for operation.
CHECKING THE ROLLERS
Your laminator has pneumatic pressure adjustment
with fine-tune control for a smooth, flat finish.
Correct adjustment of the pressure rollers’ height is
essential for safe and proper operation. Check this
prior to every use.
Check the vertical movement of the top rollers
as follows:
• Press the Roller switch UP. The top roller should
rise smoothly and evenly on both ends.
• Press the Roller switch DOWN. The top roller
should lower smoothly and evenly on both ends.
• Repeat this procedure for both front and back top
rollers.
IMPORTANT! The silicone covering of the
rollers is soft. Do not scratch the surface with a
sharp object or fingernail.
WARNING! If your laminator does not operate
correctly, contact Technical Service
immediately.