Specifications

15
1
2
3
4
TOP MOTOR CONTROL PANELS
Figure 8. Top Motor Control Panel
MOTOR CONTROL PANEL OPERATION
• The Motor Control Panels are centrally located on
the top of both side cabinets.
• This location provides easy access from all sides of
the laminator.
• Right or left-handed operators can use either panel
to make speed or direction processing adjustments
from the front or rear of the laminator.
• A change made to either panel affects the settings
of both panels.
3. Speed Adjustment Knob
Use this knob to adjust the speed of the roller rotation.
Turn the knob clockwise to increase the speed of the
roller rotation and counter-clockwise to decrease the
speed. The speed of the rollers is continuously
adjustable between 0 and 15 ft /min. (0 and 4.5m/min.).
The roller speed can be viewed in the top display
readouts on both the front and back control panels.
4. Reverse Roller Direction Switch
Pressing this switch runs the rollers in the reverse
direction when standing at the front of the laminator.
This direction will be used when processing cold
pressure-sensitive films from the rear of the laminator
through the pull rollers.
5. Motor Stop Switch
Pressing this switch stops the roller rotation.
NOTE: You must press this switch before you can
press the opposite direction switch.
6. Forward Roller Direction Switch
Pressing this switch runs the rollers in the forward
direction when standing at the front of the laminator.