Owner`s manual

10
6500 XT PROCESS CONTROL CHART
Process: _________________________________
Application Use: ___________________________
Top Unwind Shaft:__________________________
Bottom Unwind Shaft: _______________________
Front Control Panel Settings
Top Roller Temp: __________________________
Bottom Roller Temp: ________________________
Main Roller Pressure: ________________________
Cooling Fan: On ___ Off ___ Above ____ Below ____
Back Control Panel Settings
Top Pull Roller Temp: _______________________
Pull Rollers: Up ___________/ Down ___________
Pull Roller Pressure: ________________________
Pull Clutch Tension: ________________________
NOTE: We recommend that you make a
photocopy of this page. With each successfully run
application, record the process and settings and a
diagram of the webbing procedure. Keep the record
so the application can be repeated at a later date.
HINT: If a standard image is made available for
each new process then sales materials and samples
can be developed for reference.
Motor Control Panel Settings
Motor Direction: Forward _______/ Reverse _______
Motor Speed Setting: ________________________
Webbing Settings
Chill Idlers: [Over/Under] 1st / 2
nd
______________
Web Tension Top Unwind Shaft:
Light ________/ Med. _________/ Heavy _________
Web Tension Bottom Unwind Shaft:
Light ________/ Med. _________/ Heavy _________
Shim Wheel Settings: Front ________/ Rear________
Images: Sheet Fed ___________/ Roll Easel _______
Top
Main Roller
Top
Pull Roller
Front Top
Supply Shaft
Rear Top
Supply Shaft
Bottom
Main Roller
Bottom
Pull Roller
Chill
Idler
Shim Wheel
Print Guide
Front Table
Shim Wheel
Covered
Foot
Switch
Front
Chill
Idler
Rear
Front
Bottom
Wind-up
Rear
Bottom
Wind-up
Rear
Bottom
Supply
Shaft
Front
Bottom
Supply
Shaft
Rear
Roll
Easel
Front
Roll
Easel
Rear Top
Wind-up
Front Top
Wind-up
Top
Idler
Rear Table
Covered
Foot
Switch
Fan
Tube
Fan
Tube
Bott
Idler
Bott
Idler
Figure 5. Blank Webbing Diagram