Owner`s manual

MEDIA: Electrostatic Transfer
FILMS:
-- -- -- Front Bottom Unwind Shaft: Marking Film
(Vinyl)
_____ Rear Bottom Unwind Shaft: Transfer Media
TRANSFER PROCESS SETTINGS:
Front Control Panel
Top Roller Temp.: 300°F (149°C)
Bottom Roller Temp.: OFF
Main Roller Pressure: 85-90 PSI
Cooling Fan: ON, Under Chill Idlers
Back Control Panels
Top Rear Roller Temp.: Over-laminate Determined
Pull Rollers: Down
Pull Roller Pressure: 35-40 PSI
Pull Clutch Tension: 40-60 PSI
NOTE: The speed can be adjusted (slower or faster)
depending on at what speed you have the best total
transfer of the toner into the film.
NOTE: Low temperature heat assist (120° F/49°C) on
the Over-laminate will reduce silvering on the final
output.
NOTE: The clutch tension pressure should not exceed
40 psi. This will prevent excessive pull on the film,
affecting the output.
Motor Control Panels
Motor Direction: Forward
Motor Speed Setting: 1-10 FPM (.3-3.0 MPM)
Webbing Settings
Web Tension Marking Film: Light
Web Tension Transfer Media: Heavy
Chill Idlers: Over 1st / Under 2nd
Front Shim Wheel Settings: -1/16 (-2mm)
Rear Shim Wheel Settings: ‘0’
IMPORTANT! We recommend maintaining these tem-
peratures during long runs to ensure the highest-quality
output. Do not allow the top roller temperature to drop
below 290° F (143°C). Allow the bottom roller to cool
down if the temperature exceeds 160° F (71°C) before
continuing the process.
TRANSFER PROCESS CONTROL CHART
7
Idler
Rear Table
Removed
To p
Main Roller
To p
Pull Roller
Rear Top
Supply Shaft
Bottom
Main Roller
Bottom
Pull Roller
Chill
Idler
Shim Wheel
Print Guide
Front Table
Front
Rear
Rear
Bottom
Wind-up
Rear
Bottom
Supply
Shaft
Front
Bottom
Supply
Shaft
Rear
Roll
Easel
Front
Roll
Easel
Rear Top
Wind-up
Front Top
Wind-up
To p
Idler
Covered
Foot
Switch
Fan
Tube
Bott
Idler
Over-laminate
Release Liner
Remove front
bottom wind-up
Covered
Foot
Switch
Chill
Bott
Idler
Front Top
Supply Shaft
Shim Wheel
Pressure-sensitive
Over-laminate
Pressure-sensitive
Over-laminate
Finished Product
Marking Film (Vinyl)
Toner receiving Side
Media after
toners removed
Transfer media
Toners facing in
Figure 4. Dry Transfer Process Webbing Diagram