Specifications

6
UNPACKING THE LAMINATOR
1. Remove the transport packing and the plastic shrink-
wrap that the laminator is wrapped in to avoid
moisture penetration during shipping.
2. Remove the accessory kit package from the top of the
laminator. This kit includes the tools necessary for
installation.
3. Remove the two footswitches from the top of the
laminator. Remove the foam wrapped around them.
4. Place the footswitches in positions that are readily
accessible while feeding images.
5. Remove the lower table bumpers using allen wrench
provided. Lift and lock table in the upright position.
Reinstall the lower table bumpers.
6. Remove the air tube, secured to the upper unwind
shaft and its protective wrapping.
7. Insert the air tube in the lower position and position
the magnetic fan opening cover (included in the
accessory kit) over the top opening.
8. Cut and remove the tie straps securing the Unwind
Shafts.
9. The Quick Connect Coupler (included in the
accessory kit) can be used to connect to your air
compressor.
CAUTION: The top roller goes up automatically
when air is connected.
10. Remove the foam placed between the top and bottom
rollers.
WARNING: Do not use open blades to remove the
protective paper on the rollers.
11. Remove the stickers securing the protective paper on
the rollers using fingers only.
12. Gently pull the paper towards you to unwind off the
rollers.
CAUTION: Roller damage caused by improper use
of cutting tools will void the user’s
warranty. Small cuts and imperfections
in the rollers greatly affect the quality
of the output and roller replacement
costs are expensive.
LEVELING FEET OPTION
A non-standard set of Leveling Feet are available as an
option. The following procedure describes leveling
procedures to be followed if your machine is equipped
with this feature.
1. Thread the optional leveling feet (which if purchased
are included in the accessory pack) onto each of the
four transport bolts located in the corners of the
cabinets. Tighten securely.
2. Use the ½ in. wrench to turn the transport bolts down
until the leveling feet are positioned flat against the
floor.
3. Insert a 3 ft. x 1 ft. (91cm x 30cm) piece of foam
board across the two center chill idlers and place the
level in the center on top of this foam board.
4. Adjust the leveling feet for each side cabinet until
level.
5. Next, place the level on the tops of each of the
cabinets lengthwise and adjust the leveling feet from
the front to the rear of the cabinet as needed.