Specifications

WORKSPACE / CONNECTING THE LAMINATOR

WORKSPACE

Keep the area around your laminator clear with adequate

space around it so you can feed, receive and trim mounted

and/or laminated images.

We recommend a room size of 20 ft.x 18 ft. (6.1 M x 5.49

M) to accommodate a laminator and two 4 ft. x 8 ft.(1.22

M x 1.44 M) tables on castors for finishing and/or layout

work. This area is required for loading and unloading rolls

of material onto the unwind shafts, and feeding and

receiving the maximum mounting board lengths into the

laminator correctly.

NOTE: Maximum board lengths are up to 10 ft. (3.5

M) long.

Work area should be level, flat, and well lit.

CONNECTING THE LAMINATOR

Connect the laminator in accordance with details as listed

on the identification plate attached to the rear of the

laminator. Refer also to the Technical Specifications page

for additional information.

CAUTION: SEAL Graphics recommends that a

licensed electrician, in accordance with

electrical codes in your area, install

your main power or the warranty will

be void. Specifications subject to

change without notice.

SEAL Graphics recommends installation of a Ground

Fault Interrupter (GFI) circuit breaker if operating the

laminator near water or in an area of high humidity.

61"/155 cm

Maximum board length

Room Length = 2 x max. board length + 54" (137 cm)

54"/137 cm

Minimum Room Width =15 feet/4.5 meter

15"/ 38 cm

Minimum Room Length = 15 feet / 4.5 meter

Rolls of Media

15"/ 38cm

Unwind Shaft

Figure 1: Workspace Area Diagram