Specifications

43
LIMITED WARRANTY
SEAL
®
Graphics warrants to the original consumer
purchaser that each new SEAL
®
Image
®
Laminator, which
proves defective in materials or workmanship within the
applicable warranty period, will be repaired or, at our
option, replaced without charge.
Effective November 1st, 2002 the applicable warranty
period for New Equipment shall be one year (parts), six
months (labor and rollers) from date of purchase.
This warranty extends to and is enforceable by only the
original consumer purchaser, and only for the period
(during the applicable term), which the product remains in
the possession of the original consumer purchaser.
"Original consumer purchaser" means the person who first
purchased the product covered by this warranty other than
for purpose of resale. This warranty does not apply if it is
found that at any time the equipment has not been used
for its intended purpose.
Effective November 1st, 2002 the applicable warranty
period for Refurbished Equipment shall be ninety days
(parts and labor, excluding rollers). Rollers are not covered
under warranty. The applicable warranty period for Demo
Equipment shall vary, not exceeding the maximum
warranty period stated herein. All Demo Equipment comes
with a specific warranty, which will be stated at the time of
purchase. If warranty period is not detailed in writing,
there is no remaining warranty.
Please ask your dealer, distributor, or sales representative
for details.
NOTE: Used and Not Refurbished Equipment is sold on
an “AS IS” basis with No Warranty.
For more information regarding this warranty, please
contact your distributor.
WARNING: Any unauthorized changes or
modifications to this unit without our
prior written approval will void the
user’s warranty and will transfer health
and safety obligations to the user.
WARNING: Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment
NOTE: This equipment has been tested and found
to comply with the limits for a class A digital
device, pursuant to part 15 of the FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is
operated in a commercial environment. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with Owner’s
Manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the
interference at their own expense.
©Copyright SEAL
®
Graphics 2003
All rights are reserved. No part of the document may be
photocopied, reproduced, or translated to another
language without the prior written consent of SEAL
Graphics.
The information contained in this document is subject to
change without notice and should not be construed as a
commitment by SEAL Graphics.
SEAL Graphics assumes no responsibility for any errors
that may appear in this document. Nor does it make
expressed or implied warranty of any kind with regard to
this material, including, but not limited to, the implied
warranties of merchantability and fitness for a particular
purpose.
SEAL Graphics shall not be liable for incidental or
consequential damages in connection with, or arising out
of the furnishing, performance, or use of this document
and the program material, which it describes.
Trademarks Credits
SEAL
®
is a registered trademark of SEAL Graphics.
Image
®
is a registered trademark of SEAL Graphics.
AquaSEAL
®
is a registered trademark of SEAL Graphics.
ProSEAL
®
is a registered trademark of SEAL Graphics.