Specifications

35
ERROR CODES
Error Messages In
Speed Display
Cause Solution
• One of the Emergency stop
push buttons is pressed
• There is no power to the Main
board
• Reset the Emergency stop pushbutton
• Check the Emergency Stop Buttons’ wiring
• Check the Fuses
• Rear Photo-eye is interrupted
• Remove the obstruction
• Adjust the Photo-eye sensor
• Front Photo-eye is interrupted
• Remove the obstruction
• Adjust the Photo-eye sensor
• One of the Auxiliary Stop
Switches has been pressed
• Check to see if something is pressing on the
switch
• Restart the machine
DANGER: ONLY QUALIFIED SERVICE PERSONNEL SHOULD PERFORM MAINTENANCE TASKS
WHICH REQUIRE MORE THAN A SIMPLE ADJUSTMENT OR RESET.
Error Messages In
Temperature Display
Cause Solution
No Display Lights
• No Power Supply • Check the Fuse F3 on main board.
E0.0
• No communication between
control board and panel for
five seconds
• Reset Stand-by On/Off Switch
• Contact Technical Service (See rear cover)
E2.0
• Photo eye F1 (in front of front
roll) failed its check
• Check eye path for obstruction
• Reset Stand-by On/Off Switch
• Contact Technical Service (See rear cover)
E2.1
• Photo eye R1 (behind front roll)
failed its check
• Check eye path for obstruction
• Reset Stand-by On/Off Switch
• Contact Technical Service (See rear cover)
E2.2
• Photo eye F2 (in front of rear
roll) failed its check
• Check eye path for obstruction
• Reset Stand-by On/Off Switch
• Contact Technical Service (See rear cover)
E2.3
• Photo eye R2 (behind rear roll)
failed its check
• Check eye path for obstruction