Specifications

31
PROCESS CONTROL SHEET
NOTE: We recommend that you make a photocopy of this page. With each successfully run application, record
the process and settings and a diagram of the webbing procedure. Keep the record so the application
can be repeated at a later date.
HINT: If a standard image is made available for each new process then sales materials and samples can be
developed for reference.
LAMINATOR SETTINGS
Media:
Process: ________________________________________
Application Use:__________________________________
Top Unwind Shaft:________________________________
Bottom Unwind Shaft:_____________________________
Front Control Panel Settings
Top Roller Temp: ________________________________
Bottom Roller Temp: _____________________________
Main Roller Pressure:______________________________
Cooling Fan: On / Off_____________________________
Rear Control Panel Settings
Pull Rollers: Up / Down ___________________________
Pull Roller Pressure: ______________________________
Pull Clutch Tension: ______________________________
Motor Control Panel Settings
Motor Direction: Forward / Reverse __________________
Motor Speed Setting: ______________________________
WEBBING SETTINGS
Chill Idlers: [Over/Under] 1st / 2
nd ___________________________
Web Tension Top Unwind Shaft:
Light / Med. / Heavy_______________________________
Web Tension Bottom Unwind Shaft:
Light / Med. / Heavy_______________________________
Shim Wheel Settings: Front / Back ____________________
Images: Sheet Fed / Roll Easel________________________
Figure 28: Blank Webbing Diagram