Specifications

TABLE OPERATION

PIVOTING TABLE USE FOR WEBBING

To facilitate webbing, remove the top wind-up idler and

set it aside.

Figure 11: Table Release Handle

Grasp and pull the table release handle located UNDER

the center of the table (Figure 11, Item 1) which pulls the

table plungers towards the center of the table. Pivot the

table down, away from the rollers (Figure 12).

Figure 12: Pivoting Table Down

Reach through the opening between the table and rollers

and pull the bottom film up and pass it behind the bottom

idler.

Pull the film up and place it over the top roller.

Reposition the table by lifting the outer edge upwards and

pivot in towards the roller (Figure 13).

Figure 13: Table Pivoting Up

Grasp and pull the table release handle, lift and rotate the

table in the level postion. Release the handle allowing the

plungers (Figure 14, Item 1) to seat in locked position,

securing the table in the normal operating position.

Figure 14: Locking Table Into Position

When seated, the plungers hold the table in the horizontal

position by locking into the main frame, both left and

right, of the 600 MD. (See Figure 14)

NOTE: Table operation is the same for both the

front and rear tables.

Lock