Specifications

15
SET-UP AND OPERATION
After you have reviewed the operational details provided and prior to operations check all controls to become
familiar with their operation and function.
PRESTART CHECKS
CHECK THE MAIN POWER
1. Position the Stand-by Power Switch in the up position
and verify that the front displays on the control panel
light up.
2. The center red switch on the top cabinet control panel
should be illuminated.
CHECK THE EMERGENCY STOP BUTTONS
1. Press one of the Emergency Stop Buttons and the
laminator should stop operation.
2. Rotate the Emergency Stop Button clockwise to reset.
3. Repeat this procedure with all four Emergency Stop
Buttons.
CHECK THE HEATER CONTROLS
1. Press the Top Heater On/Off button once; the
corresponding LED should be lit.
2. The readout will display the ambient temperature.
3. Press and hold the top heater Up Arrow to increase
the temperature set point. Watch the readout for 5
minutes to verify that the temperature increases.
4. Press and hold the Down Arrow to decrease the
temperature set point.
5. Press the top heater On/Off button again once; the
corresponding LED should not be lit.
6. Repeat this procedure for the Bottom Heater.
CHECK THE MOTOR AND FOOTSWITCH
1. Push the green Motor Forward Switch and the rollers
should rotate in the forward direction.
2. Press the center red Motor Stop Switch and the rollers
should stop rotating.
3. Press the green Motor Reverse Switch and the rollers
should rotate in the reverse direction.
4. As you turn the speed control knob clockwise the
speed of the rollers should increase and the speed
readout (top display on front control panel) should
increase in number.
5. Turning the speed control knob counter-clockwise
should decrease the speed of the rollers and the speed
readouts should decrease in number.
6. Press the footswitch and the rollers should rotate in
whichever roller direction that was last pressed at a
speed of 2.0 ft (0.6 M) per minute. Check both
footswitches for operation.
CHECKING THE ROLLERS
Your laminator has pneumatic pressure adjustment with
fine-tune control for a smooth, flat finish. Correct
adjustment of the pressure rollers’ height is essential for
safe and proper operation. Check this prior to every use.
Check the vertical movement of the top rollers as
follows:
1. Press the Roller switch UP. The top roller should rise
smoothly and evenly on both ends.
2. Press the Roller switch DOWN. The top roller should
lower smoothly and evenly on both ends.
3. Repeat this procedure for both front and rear top
rollers.
CAUTION: The silicone covering of the rollers is
soft. Do not scratch the surface with a
sharp object or fingernail.
WARNING: If your laminator does not operate
correctly, contact Technical Service
immediately.