Specifications

13
PULL ROLLER PRESSURE CONTROLS
Figure 6: Pull Roller Pressure Controls
The Pull Roller Pressure Control Panel is located on the
left side cabinet when facing the rear of the laminator.
The operator can adjust the amount of tension that is
directly applied to the laminate between the main and pull
rollers.
The amount of tension applied affects the output and
extreme pull tension will stretch the hot films causing
outfeed waves in the finished product. This is a factor with
films such as Print Guard
®
, which stretches easily.
Excessive tension will also cause downward curl in the
finished product.
The standard setting for normal operation is 40-60 PSI.
1. AIR REGULATOR KNOB
This knob adjusts the pulling tension of the bottom pull
roller. Turn clockwise to increase the amount of pull
tension and turn counter-clockwise to decrease the
amount.
2. AIR PRESSURE GAUGE
Indicates the PSI reading for the pulling tension of the
bottom pull roller. The standard setting for normal
operation is 40-60 PSI.
CAUTION: Excessive pull clutch tension will cause
premature wear to the drive system and
may cause damage to the laminator.
Use the minimum amount required for
the laminating process.
0
60
2
1