Operating instructions

9
Safety Information
The IMAGE 60C/S laminator is provided with safety equipment to promote safe machine operation.
You should however take note of the following.
Read and make sure you understand these safety and operating instructions.
WARNINGS:
Hot surfaces – Danger of getting injured by hot parts.
Be careful with hot parts. The heated rollers can have a surface
temperature of up to 135
0
C (275
0
F). Do not touch the rollers. Even after
the laminator has been switched off, the rollers remain hot for a long time.
Rotating parts – Danger of getting injured by rotating parts.
The laminator is equipped with an opto-electronic protective device to
avoid contact with the rotating rollers. Make sure that these safety
provisions are always in operation/fitted. Make sure that clothing, long
hair etc. are not caught by the rotating rollers which might result in being
trapped.
The motor will stop automatically when the opto-electronic protective
device in front of the main rollers is interrupted.
THIS DOES NOT HAPPEN
when the combined operation of the slow-
mode and the foot pedal is being used. In this case the laminator will only
work at 0.5 m/min (1.6ft/min) and while the slow-mode is being used an
audible signal will be heard.
Electric parts – Danger of getting injured by electricity.
Do not remove the side panels of the IMAGE 60C/S laminator because
there is a danger of getting injured by electricity. Only remove panels to
carry out maintenance. In this case make sure the main electrical supply is
off.
Do not put heavy objects on the power supply cable.
Danger of damage to equipment or injury to persons.
This indicates the possibility of damage to equipment or injury to persons if
the wrong tools or equipment are used.