Operating instructions

29
Supply shafts
Loading rolls
The machine has 2 pivoting, cantilevered supply shafts with integrated unwind brake for easy
loading and webbing. One supply shaft is located at the top rear side of the laminator and one
supply shaft is located at the bottom rear side of the laminator. Both shafts are of the auto-grip
design.
To load film, rotate the supply shaft in a position that the rubber blocking cords are on the top and
bottom of the shaft. Release the unwind tension if necessary, to turn the shaft to the correct
position.
Pull the top and/or bottom unwind shaft out of the snap-in bracket and turn backside upon pivot.
Load the required roll(s) onto the supply shaft(s).
Turn the supply shaft back and push into the snap-in bracket.
Centre the rolls on the supply shaft by using the integrated tape measure.
WARNING:
Do not overload the supply shafts while loading/unloading.