Operating instructions

26
Roller up/down and roller pressure
Roller up/down
Rotation of the hand wheel clockwise will move the roller down, the value of the nip setting (the
thickness of the panel to be laminated) is shown in the display [3].
Rotation of the hand wheel counter-clockwise will move the roller up.
The nip setting can be set for values: –1.0 mm to 27.0 mm (-3/16” to 1 1/16”)
Roller pre-pressure setting
Rotation of the pre-pressure knob clockwise will increase the roller pre-pressure, the value of the
pre-pressure is shown in the display [13].
Rotation of the pre-pressure knob counter-clockwise will decrease the roller pre-pressure, the value
of the pre-pressure is shown in the display[13].
The pre-pressure can be set for values 0.63 N/mm to 1.60 N/mm ( 3.60 Lbs/inch to 9.10 Lbs/inch ).
Recommended starting pre-pressure is 1.10 N/mm ( 6.30. Lbs/inch )
WARNING:
Take care that the maximum value of pressure does not exceed 1.70 N/mm. Excessively high
pressure will damage machine parts.
WARNING:
Display value above 1.60 N/mm will result in the following being displayed:
1.70 N/mm - 1.90 N/mm > flashing
, 2.00 N/mm > EEE and laminator will stop.
Roller UP/DOWN handle
Pre-pressure setting knob